Safety operation rules for CNC grinding machines

The safety operation regulations for CNC grinding machines mainly include:

1. The coolant should be selected appropriately to avoid problems and affect the cooling effect

If there are burrs on the workpiece, they should be removed before processing to avoid affecting the processing effect

When the grinding wheel is very close to the workpiece, hand cranking should be used to observe whether the workpiece has protrusions or indentations

4. Machine tools should be kept clean and tidy. Before driving, check if the position of the handle and travel limit is correct

5. Flat grinding wheels should not extend more than 25 mm, and the grinding wheel blocks should be kept parallel

6. When the grinding wheel of the CNC grinder has not completely stopped, it is impossible to clean the coolant or perform grinding and replacement

If the grinding wheel is not sharp, it can be repaired with diamond

8. When installing the grinding wheel, be gentle, especially with a new one. After installation, a ten minute idle test run is required to observe for any deviation, vibration, or other phenomena. It can only be used when there are no issues